This Glyph script creates connectors for a circle given the center point and radius. The circle consists of two connectors, each of 180 degrees of arc. The circle is created in the current drawing plane. An optional dimension can be specified. A Tk interface is provided for setting the parameters.

Download:

ConCircleCenterAndRadius.glf

Author:

glyph@pointwise.com at Pointwise, Inc.

Date Posted:

25 August 2004

Category:

Create Connectors

Minimum Requirements:

Gridgen V15.0, Glyph V1.6.4

Disclaimer:

Scripts are freely provided. They are not supported products of Pointwise, Inc. Some scripts have been written and contributed by third parties outside of Pointwise's control.

TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, POINTWISE DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, WITH REGARD TO THESE SCRIPTS. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, IN NO EVENT SHALL POINTWISE BE LIABLE TO ANY PARTY FOR ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF BUSINESS INFORMATION, OR ANY OTHER PECUNIARY LOSS) ARISING OUT OF THE USE OF OR INABILITY TO USE THESE SCRIPTS EVEN IF POINTWISE HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES AND REGARDLESS OF THE FAULT OR NEGLIGENCE OF POINTWISE.